 |
D210 MATERIAL SAFETY DATA SHEET
|
Important: The information herein has been compiled from sources believed to be reliable and is accurate to the best of our knowledge. However, Coatings International, Inc. cannot give any guarantees regarding information from other sources and expressly does not make any warranties, nor assumes any liability, for it's use. If apprised of changes, updated MSDS sheets will be promptly issued. Users must make their own determination regarding the suitability of the product for their own purpose prior to use.
VIEW / DOWNLOAD (Windows - "Right Click", Mac - "Option-Click") a printable PDF version of this document.
I - MATERIAL IDENTIFICATION AND INFORMATION
II - PHYSICAL/CHEMICAL CHARACTERISTICS
III - FIRE AND EXPLOSION DATA
IV - REACTIVITY HAZARD DATA
V - HEALTH HAZARD DATA
VI - CONTROL AND PROTECTIVE MEASURES
VII - PRECAUTIONS FOR SAFE HANDLING AND USE/LEAKS
RELATED DOCUMENTS
SECTION I - MATERIAL IDENTIFICATION AND INFORMATION
Components - Chemical Name & Common Names
(Hazardous Components 1% or greater: Carcinogens 0.1% or greater)
| CHEMICAL NAME (COMMON NAME) |
CAS # |
% |
OSHA PEL (PPM) |
ACGIH TLV (PPM) |
| Crystalline silica, mullite, glass |
combination of:
14808-80-7
1302-93-8
65997-17-3
|
6% |
0.1 respirable dust |
0.1 respirable dust |
SECTION II - PHYSICAL/CHEMICAL CHARACTERISTICS
| 1) BOILING POINT |
No Data Available
|
| 2) SPECIFIC GRAVITY |
N/A |
| 3) VAPOR PRESSURE |
N/A |
| 4) MELTING POINT |
N/A |
| 5) VAPOR DENSITY |
N/A |
| 6) EVAPORATION RATE |
Not Applicable |
| 7) SOLUBILITY IN WATER |
Negligible |
| 8) WATER REACTIVE |
N/A |
| 9) APPEARANCE & COLOR |
Dry Gray Powder, Odorless |
SECTION III - FIRE AND EXPLOSION DATA
FLASH POINT & METHOD:
Noncombustible
AUTO-IGNITION TEMPERATURE:
N/A
FLAMMABILITY LIMITS IN AIR % BY VOLUME: N/A
LEL-N/A
UEL-N/A
EXTINGUISHER (MEDIA):
N/A
SPECIAL FIRE FIGHTING PROCEDURES:
N/A
UNUSUAL FIRE AND EXPLOSION HAZARDS:
None
SECTION IV - REACTIVITY HAZARD DATA
STABILITY:
Stable
CONDITIONS TO AVOID:
None known.
INCOMPATIBILITY (Materials to Avoid):
None known.
HAZARDOUS DECOMPOSITION PRODUCTS:
None
HAZARDOUS POLYMERIZATION:
Will not occur
SECTION V - HEALTH HAZARD DATA
1) PRIMARY ROUTES OF ENTRY:
- Inhalation-yes
- Skin absorption-no
- Ingestion-no
2) CARCINOGEN LISTED IN:
- NTP - yes
- IARC MONOGRAPH - yes
- OSHA - no
3) HEALTH HAZARDS
ACUTE:
Eye contact: may cause irritation.
Skin contact: May cause dehydration and irritation.
CHRONIC: Repeated exposure may cause delayed lung injury (silicosis, cancer).
4) SIGNS AND SYMPTOMS OF EXPOSURE:
Sneezing and dryness of mucous membranes (inhalation). Redness and tearing (eye exposure). Dryness, itching and burning (skin exposure).
5) MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Asthma and lung diseases.
6) EMERGENCY FIRST AID PROCEDURES:
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention if irritation persists. See below.
7) EYE CONTACT:
Flush with large amounts of water for at least 15 minutes. See a physician.
8) SKIN CONTACT:
Wash thoroughly with soap and water.
9) INHALATION:
Remove subject to fresh air.
10) INGESTION:
Contact physician immediately
SECTION VI - CONTROL AND PROTECTIVE MEASURES
RESPIRATORY PROTECTION (Specify type):
Wear NIOSH-certified dust respirator suitable for concentrations encountered. Observe OSHA regulations for respirator use (29 CFR 1910.134)
PROTECTIVE GLOVES:
Cotton gloves are usually sufficient to protect hands from irritation.
EYE PROTECTION:
Chemical goggles
VENTILATION TO BE USED:
Local exhaust - Recommended
Mechanical (general) - Recommended
OTHER (Specify):
Avoid grinding, milling, or otherwise generating respirable dust. Use with adequate ventilation. Avoid breathing dust. Wash thoroughly after handling. Safety shower and eyewash fountain should be within direct access.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE/LEAKS
STEPS TO BE TAKEN IF MATERIAL IS SPILLED OR RELEASED:
Sweep, scoop or vacuum discharged material.
WASTE DISPOSAL METHODS:
Landfill at a permitted facility according to current local, state, and federal regulations. Material is not an RCRA hazardous waste.
ENVIRONMENTAL IMPACT:
None known. Not a listed toxic chemical under SARA Title III, #302, 304, 313.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:
Do not breath dust.
Revised May 2000
FOR ADDITIONAL INFORMATION, GO TO:
VIEW A DIFFERENT TOUGH STUFF PRODUCT
|
See also:
|
